Boron Nitride Hardcoat®-CM is the same “fired” constituency as our original tough/abrasionresistant boron nitride coating … except the “CM” version contains NO acrylics. BN-Hardcoat - CM is non-wetting with molten aluminum, magnesium, zinc and other non-ferrous metals and their drosses. Ideal for high-wear uses where all other boron nitride coatings fail. Can be applied to hot substrates, whereas the original BN Hardcoat should ONLY be applied and dried at room temperature or below 80 C.

Specifications

Active Ingredient ....... .............. BN Max Use Temperature Air/Vac/Inert 1652 F/ 900 C Use Atmosphere All Fired Composition >40% BN Liquid Carrier Water Binder Phase Potassium Silicate Active Ingredient Level Medium Loading Brookfield Viscosity (cps) 135-515 @3/60 Specific Gravity 1.29 Color Gray Shelf Life (months) >12 Coverage (ft2/gal) 100-400 Coating pH 8-9 H F R Ratings 1-0-0 Substrate Use All

Ideal Use

• Immersion Tubes

• Metal Troughs, Molds

• Ladles, Skimmers

• Dross Buggies

• Shot Screens

• Stalk Tubes

• Funnels

Use Notes

1. DO NOT DILUTE.

2. Resuspend the paint.

3. Clean surface of oils, dirt, scale etc.

4. Apply 1 to 2 thin layers by brush or spray.

5. Allow to thoroughly dry between coats and before use.

Safety and Handling Information

• Consult SDS before use.

• Avoid freezing.

• For Industrial Use only

• Avoid breathing of spray/vapors.